Newsletter Sign-Up

The Country Living Communiqué is a quarterly letter (via email) with fabulous recipes, special offers, healthy living wisdom, news, upcoming products and more!
 
  * = Required Field
Email Marketing You Can Trust

A Look Inside The Country Living Grain Mill

The Country Living Mill is without a doubt the most rugged manual grinder on the market today. Two rugged Ball Bearings. The only grinder like it. Built smart for tough times.

An illustration of the bearings inside the Country Living Grain Mill

It is the only grinder, of which I am aware, that utilizes two industrial-grade ball-bearings. Other comparable grinders that cost around $200.00 more than the Country Living mill use brass bushings.

Many grinders use only one large bushing, but the Country Living Mill has two sealed ball bearings spaced apart* which increases the stability of the drive shaft and reduces bearing strain.

*The bearing placement can be seen highlighted in red on the diagram to the right.

The photo below that shows what the grinder looks like when the threaded adjustment knob, the rotating burr, the drive key and grain auger have been removed. The grinder must be broken down to this point to install the bean and corn auger. If you wished, you could now pull the drive shaft out of the mill from the crank side. You can see that this grinder is amazingly easy to take apart and clean. Picture of the grinder on the Country Living Grain Mill



The Keys

If you are using the large auger, there are three keys that must be installed for the grinder to operate.

The standard auger set-up only requires two keys. The purpose of the keys are to lock the different rotating parts of the grinder to the drive shaft so they all turn as one unit. There's a key locking the pulley wheel to the drive shaft, another to lock the bean and corn auger to the drive shaft, and on the end of the grinder a third key to lock the rotating burr of the grinder to the The Key...drive shaft.

The keys are quite small and are easily lost. When taking the grinder apart, be mindful of the keys. Before any disassembly, clean your work area. More than one key has been lost in a bowl of wheat or flour. This is especially true for those who do not know to keep an 'eye out', aPhoto of the Keys used inside the Country Living Grain Mills the key can quite unnoticeably fall out of the groove in the drive shaft during disassembly, then get lost in whatever floury mess you have at the base of the grinder.

For many folks, the first indication there's something wrong is when they reassemble their grinder, and the rotating burr doesn't turn when they crank the handle. By this time, the key may very well be long gone. Be careful with the keys. The grinder won't work without them.


Parts of the Country Living Grain Mill Grinding Mechanism

Photo of the Country Living Mill Grinding MechanismA. The Fixed Burr or Plate. Held into position by three screws.

B. The Rotating Burr or Plate

C. The Threaded Coarseness Adjustment Knob

D. The Grain Auger

E. The Key

F. Three or Four Washers.

Click here to view Installation Instructions

Top of Page